Z-Patch301
Z-PATCH301 is a ready-mixed mortar used for structural repair plastering. It is a non-shrinking type of plaster and a thin fairing repair plaster for repairing concrete surfaces.
Product Category
Size
Contact
Z-PATCH301 Structural repair mortar, dense, tough, good adhesion, easy to plaster, no sagging, can withstand more than 500 ksc of compressive strength. Used to repair small concrete surfaces caused by air bubbles, demolition, and can also be used instead of non-shrink grout in cases where it is inconvenient to close the pouring mold, including plastering to repair concrete structures or precast concrete panels.
- Concrete surface repair work, such as peeling, porosity
- Cracks, chips on edges, such as wall corners, stair nosings, cracks in concrete walls or plaster
- Repair damaged structures or reinforce them
- Repair cavities caused by incomplete pouring of concrete
- Repair columns or beams of structural forces that have been corroded
- Can withstand high compressive forces
- Has good adhesion, can be used for both horizontal and vertical repairs
- Durable and highly strong
Mix Z-PATCH301 with clean water in the ratio of water: product 20% (approximately 5 liters of water) : Z-PATCH301 1 bag (25 kg). Mix thoroughly using a low speed mixer for approximately 2-3 minutes to achieve a smooth, lump-free, homogeneous consistency.
Surface preparation
- Before use, clean the surface to be clean, free from stains such as oil, grease or cement residue.
- Before plastering, the original concrete surface should be moist or soaked before using Z-PATCH301.
Mixing
Mix Z-PATCH301 with clean water in a ratio of water: 20% product (approximately 5 liters of water): 1 bag of Z-PATCH301 (25 kg). Mix thoroughly using a low-speed mixer for about 2-3 minutes for a smooth, lump-free, uniform flow.
How to use
- Apply Z-PATCH301 on the prepared area with a plastering tool, pressing firmly to allow the material to fill the surface to be repaired. You may apply a thin layer of at least 2 mm.
- In the case of repairing edges or corners Use a plastering tool to cover both sides of the corner to prevent the material from flowing or tipping over to the other side while plastering.
- Repeat until you reach the desired thickness. Let it dry before smoothing it out with a trowel.
Z-PATCH301 is an alkaline substance, made from substances that are not harmful to health. Hygiene precautions should be followed. Operators should wear chemical protective clothing, gloves and eye protection and should be in a well-ventilated area. In case of skin contact, wash with soap and plenty of water. In case of eye contact, rinse with plenty of water and seek medical attention immediately.
Technical data
- Physical characteristics………………….……..……..Gray powder
- Density……………………………~1.38 kg/L
Other required data
- Package size: 25 kg/bag
- Shelf life 12 months after opening